home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
QRZ! Ham Radio 13
/
QRZ Ham Radio Callsign Database - Volume 13.iso
/
modfiles
/
djs11.txt
< prev
next >
Wrap
Internet Message Format
|
1999-04-07
|
3KB
From: KPElecServ@aol.com
Date: Tue, 30 Sep 1997 16:33:16 -0400 (EDT)
To: editor@qrz.com
Subject: DJ-S11 mod
The expanded frequencies for the Alinco two meter DJ-S11 is the same as for
the DJ-S41 radio. Remove 7 screws in the back case and battery compartment.
Carefully separate case halves. Look for very small SMD green resistor
jumper at left side near the middle of board labeled OP/CL. Remove for
expanded tx/rx. Expanded frequency range is 136.00 to 173.995 mHz.
(There are two pads here, only the one nearest outside of radio is jumpered.
Didn't experiment to see what would happen if the other one or a combination
of the two were jumpered but this might be the Mars/Cap mod.)
Art, KC7GF
-----------------------------------------------------------------
Subject: DJ-S11 Modification
Subject: EXPANDED RX / TX MOD FOR ALINCO DJ-S11
This modofication is very much like the one described by KB1MZ for the
DJ-S41. I like to thank him for initial modification.
Performing this modification will void any warranties.
All standard disclaimers apply. This mod is for the
DJ-S11T.
1. Place the radio face down on a soft towel. This avoids
scratching the display and gives you a place to put
the seven tiny screws to be removed.
2. Remove the batteries. You will lose all of the memory contents.
3. Remove the three screws on the upper rear cover, and
the four screws inside the battery compartment. The
rear cover can be lifted and removed easily, as there
are no wires to be concerned about. The antenna
connection is made by means of a gold-plated spring
contact.
4. Look for a small (about 1 mm) green surface mount
resistor (actually a 0 ohm jumper), located on the far
left side of the exposed circuit board, located to the
"northwest" of the speaker. There is a marking in white
letters, OP/CL, this resistor is located near by.
It is the only green component visible on the board.
(This radio does not have the traditional Alinco red
and blue wires which have become so familiar...)
5. Carefully remove this resistor, using a small tip soldering
iron, tweezers and a steady hand. The thin board can be
easily damaged by a high wattage soldering iron.
6. Re-assemble the radio, being careful that the thin rubber
gasket is seated around the inside edge of the rear cover.
Replace the batteries, press and hold the "F" button on the
left side of the radio, and turn it on. The display should
show all segments and markings. Release the "F" button and
the radio will now be capable of operating from approximately
136.000 MHz to above 173.995 MHz, depending on the VCO's tuning.
The display will blink if the VCO is taken out of its range.
Re-tweeking of the VCO is not recommended.
THE NOT-SO-FINE PRINT:
7. Although reception on the expanded frequencies is legal,
transmission is not. This unit is not FCC type-accepted
for anything but ham band (144 - 147.995 MHz) operation.
Again thanks to KB1MZ for his nice writeup.
73's de KG7HQ; Michael